1

In this article and this Outdoors.SE answer, the following use for stick clips is mentioned:

Having a clip stick means you can take a quickdraw out at a time. Just lower to the next bolt, clip yourself in to that quickdraw to take the weight off the rope (no need to untie). Use the clip stick to unclip the quickdraw above and bring it down. Repeat until you can touch the floor.

However the stick clip which I own is pretty long (57cm/1'10" when folded) and would be unwieldy to attach to your harness. Putting it inside a normal backpack would also be a bit inconvenient as it would stick out and you'd hit your head on it if you lean back. Additionally there's the risk of dropping it to the ground, potentially hurting your belayer.

Is there a good solution for climbing up with a stick clip?

Telescopic stick clip

Chenmunka
  • 587
  • 2
  • 8
  • 20
JonathanReez
  • 3,017
  • 2
  • 22
  • 47

2 Answers2

3

I'm only speculating, but if I frequently took the clipstick with me on the wall, I'd probably be most concerned with not dropping it while clipping. To address this, I'd drill a hole near the tip of the handle, about where I'm holding the stick on the photo, pass some metal ring through (again, like my finger and thumb go), and then use a sufficiently long loop of cord to attach this to my harness gear loop. This will prevent the stick from folding completely (like the photo shows), but not critically. Welding and epoxy might also work, and avoid the length increase, but I'm not sure if they are as foolproof.

If you find it inconvenient to carry the clipstick on your harness or in your backpack, you might consider a bandolier which would (I imagine) allow you to carry it on your back and pull out like the Witcher's sword, thus compensating for any perceived uncoolness.

enter image description here

IMil
  • 254
  • 1
  • 6
2

If you do not want to buy more equipment, you could tie your tool to a rope or a sling with a knot to give it a positive attachment and orientation control.

Fireman's pike tied to a rope This screenshot from the Halifax Fire "Hoisting Tools" https://www.youtube.com/watch?v=jrEtjEIxoj4 video demonstrates several methods using clove hitches or figure eights, plus half hitches to control the shaft.

For a plain shaft like the one you show, you could use some utility cord sling to tie some sort of friction hitch (prusik, kleimheist, etc..) around the handle and a half hitch around the head to give you an attachment point.

enter image description here

For more permanence, you could tape the friction knot in place.

Dave X
  • 1,144
  • 8
  • 17